Hubsan Q4 H111 Nano Quadcopter Setup

 

RC Pro TX Setup Guide by: Tom Zadar

 

 

Binding the quadcopter and controller:

First turn on the quadcopter power switch, place it on a level surface, then turn on the transmitter.
Push the left throttle lever to the highest position, and then pull it back to the lowest position. You will hear two beeps and the LED light will stop flashing and stay on solid.

 

 

Calibrate The Sensors:

1. Par the controller and the quadcopter.
2. Put the quadcopter on a level surface.
3. Hold the left stick to the lower right. At the same time, quickly move the right stick left and right several times until the blue LED’s flash.
Test the model to see if it will hover without drifting.
If the model is still drifting, try putting a thin piece of cardboard under the motor or motors in the same direction that the quadcopter is drifting.
Perform the sensor calibration procedure again.

 

 

Transmitter Stick Calibration:

Mode 2:
Push both sticks to the upper left position and hold. Then power on the transmitter.
Rotate both sticks twice. Hold down any trim until the LED on the transmitter blinks red, indicating successful calibration.

Mode 1:
Push the left stick to the upper left position and right stick to the upper right position and hold. Then power on the transmitter.
Rotate both sticks twice. Hold down any trim until the LED on the transmitter blinks red, indicating successful calibration.

 

 

 

“My text is Copyright 2009 – 2018 Tom Zadar”