Estes Proto-X Nano Quadcopter Setup

 

RC Pro TX Setup Guide by: Tom Zadar

 

 

Link The Controller:

Hold the throttle stick at full down and turn on the controller.
Wait until the red LED turns green.

 

Calibrate The Sensors:

1. Turn on the controller and the quadcopter.
Place the quadcopter on a flat surface.
2. Hold the left stick to the lower right. At the same time, quickly move the right stick left and right several times until the blue LED’s flash.
Test the model to see if it will hover without drifting.
If the model is still drifting, try putting a thin piece of cardboard under the motor or motors in the same direction that the quadcopter is drifting.
Perform the sensor calibration procedure again.

 

 

 

“My text is Copyright 2009 – 2018 Tom Zadar”